101 DIY Guide

Do It Yourself Guide

What You Can Do If You Have A Plumbing Problem

Many say that doing plumbing yourself is hard. But, with the right advice and know-how, it is a lot easier than you think. Here you will find some advice about how to complete a plumbing project.

To improve your home’s water-hating efficiency, you should figure out the right size water tank to provide enough hot water for the whole household. If you are aware of how many people and appliances will be using hot water, you can determine the appropriate capacity.

Schedule all your plumbing work at the same time. If a problem is minor, it can be wise to put off repair until you have more than one item to fix. This also gives you time to save up for the needed repairs. Because plumbers generally round up to the nearest hour, this also allows you to save money. The time only gets rounded up once, rather than multiple times.

Always keep exposed pipes warm during freezing winter weather. Exposed pipes may freeze when the temperature gets extremely cold. Even pipes that are inside will freeze if they are running from outside the home. A small space heater or a heat lamp deployed near vulnerable pipes will ensure that you do not have any frozen pipe problems.

If you are unable to relieve a clogged toilet with a plunger, try pouring a small bucket of water into the bowl from about waist level if the level of water in the bowl is low. The water needs to be at a low level again in order to repeat the process.

A lot of people find plumbing to be a very scary subject since it problems with it can cause much damage to their dwelling. Know where your main water valve is to avoid flooding in case of serious plumbing issues. The secret to sparing your home damage from it’s own water, is being aware of just where you can find the water register, and have the knowledge required to cut it off with haste.

Pump out your septic tank at least every five years to keep it in proper working condition. Doing so will help to avoid septic tank problems by ensuring that the tank does not become clogged with sediment. It is a small price to pay now to keep your septic in good working order and prevent having to pay for a major repair caused by a backup.

Over-tightening your pipes can be just as bad or even worse than if you under-tighten it. Over-tightening can strip the threads from the pipe or even cause too much pressure and crack it. Tighten your pipes just enough to stop leaks, no more or no less.

When installing or replacing a water heater, pay attention to the drainage pipe. The pipe extruding from the draining pipe needs to be reconnected to the water heater. It’s probably a recirculation pipe, and that can help your water remain heated without wasting water.

The valves will fuse together if they are not used. You have to turn them often to avoid sticking, and keep penetrating them with oil.

Turn off the water at the main valve immediately if you notice water on the floor by your water heater. If you don’t, then you may end up with a huge leak and major water damage.

As was discussed at the beginning of the article, while plumbing can be an extremely difficult chore for anyone to complete, it becomes significantly easier if you have the right advice and information. Use the advice from this article, and you’ll be on your way to doing your own plumbing.

101 DIY Guide © 2017